Duke X-STREAM WASH, Инструкция по установке и эксплуатации

Страница: 14 / 36

Installation and Operation of X-STREAM WASH
14
Setup Mode – OP.S
Enter the supervisor mode and press the Up or Down
buttons until OP.5 appears in the display.
Press the TEMP button to select.
When prompted for a password PSS and three dashes
toggle. The three dashes is where you enter the
password of 55.
Use the Up and Down buttons to select 55.
Press the TEMP button to enter and lock the password
and advance.
Press the TEMP button to advance between the
parameters that are available, see parameter table.
(The parameter name and its value will be swapped
in and out of the display.)
Press the
Up and Down button to change the
parameters value.
Once a value has been changed, press the
TEMP
key
to lock in this value and move on to the next parameter.
NOTE: If you do not press the TEMP button within 3
seconds after changing a parameters value,
the new value will not be saved. Push TEMP
button to access parameters again.
IMPORTANT
Before you save and exit, you need to scroll
through the parameters back to the temp display
before pressing the Temp and Start/Stop buttons
simultaneously.
To save and exit the supervisor mode, press TEMP
and START/STOP buttons simultaneously for 3
seconds and OPr appears in the display.
Press the
Down
button once and OP.b appears in
the display.
Then press the TEMP button and FIL appears in the
display and you have exited the supervisor mode
.