Ducati MULTISTRADA 1200S, Руководство пользователя, Страница: 138 / 311

LAP registration function
This function describes the "LAP" time registration.
If the function is activated (see "LAP activation/
deactivation description" page 135), the lap time can
be registered as follows:
-
the first time the flash is pressed (3) starts the
“lap timer” for the first lap and the instrument
panel shows the "START LAP" indication on the
round display (B) for 4 seconds and then returns
to the "previous" page;
- from this moment, each time that the flash is
pressed (3) the round display (B) automatically
shows the lap time for 10 seconds and then
returns to the "previous" page.
Up to 30 lap times can be stored. Once the memory
is full, the instrument panel no longer stores lap times
when the flash button (3) is pressed, and the flashing
message “LAP MEMORY FULL” is shown on the
round display for 3 seconds until the times are reset.
When the LAP function is set disabled, the current
"lap" is not stored. If the LAP function is active and
suddenly the motorcycle is suddenly turned off (Key-
Off), the function will be automatically disabled (even
if the lap timer was active, the current "lap" is not
stored).
If the time is never "stopped", it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the function is disabled. If however
the LAP function is switched on and the memory has
not been cleared, but fewer than 30 laps have been
saved (e.g. 18 laps), the Instrument panel will store
any remaining laps until the memory is full (in this
case, it will store an additional 12 laps).
This function only displays lap times being recorded;
but other data are also saved (MAX speed, MAX rpm,
rev limiter if reached) for viewing at a later time in the
Lap Memory function (stored LAPs viewing).
137