14
15
FIRST USE
To achieve optimum performance from your CaféPro follow this procedure for first use or
if you have not used your machine for a prolonged period.
SAFETY INSTRUCTION:
Never lift the Lever whilst the beverage is being dispensed. Hot liquid may
cause injury and burns.
FIRST USE
- CONTINUED
Note:
From cold the boiler will take longer to reach operating temperature
than the Group Heads. It is normal for the pumps to be automatically
operating intermittently during this process.
Note:
To prolong the life of your
CaféPro and to ensure
it continues to produce
consistent quality coffee,
Dualit recommends the
use of Water Softeners
especially in hard water
areas. For more information
visit our website on
www.dualit.com/accessories
or contact Dualit on 01293
652 500.
The Drain Valve is located
on the inside of the machine
and can be accessed by
removing the right Drip Tray.
Rotate clockwise to close
and counter-clockwise to
open.
OPEN
POSITION
CLOSED POSITION
2
THE DRAIN VALVE
3
REMOVE AND FILL
WATER TANK
Locate the Drip Trays.
Remove the Water Tank Lid
and lift out the Water Tank
using the handle.
4
SECURE INTO
POSITION
Fill Water Tank with fresh
water and refit. Replace the
Water Tank Lid.
Do not
overfill. Always remove
tank before filling as
filling in situ could cause
electric shock.
5x
Press the Lungo Button
and wait for the water to
dispense. Repeat 5 times on
each group head. This will
rinse the internal pipe work
ready for your first drink.
7
PURGE
Place two containers under
each of the Group Heads.
Ensure both Levers are
pushed down fully.
Plug in
the power cord
at the
mains and use the Power
Switch to turn on.
5
TURN ON
6
READY
NOTES;
Dosing Buttons will flash white to indicate machine
is warming up. If red see quick reference guide. The machine
is ready once the Dosing Buttons stop flashing and the Boiler
Indicator Light is blue.
Check that both Group Heads
are empty.
8
Remove and empty the two
containers. Ensure Steam Wand
is positioned over the Large Cup
Holders and open the Steam
Valve for 20 seconds to flush the
internal pipe work ready for your
first drink. Close Steam Valve.
STEAM
9
Place an empty container
under Hot Water Wand.
Open the Hot Water Valve
for 10 seconds to flush the
internal pipe work ready for
first use. Close Hot Water
Valve.
HOT WATER
Place on a flat, stable, water and
heat-resistant work surface away
from water splashes and any heat
sources. Make sure the
Drain
Valve, Steam Wand and Hot
Water Wand Valves are
closed by turning clockwise.
POSITION
1
U
N
PL
U
G W
HEN NO
T
IN
U
SE
SW
ITCH OFF &
