DTI GmbH & Co. KG
In the start display you are watching the active program (0), the puls power (1) and
the type of coil according to the model (2). In the right the current state of battery ca-
pacity. The graphic continuously writes 200 measured data. Above the zero line non
ferrous and below the zero line ferrous metals are being written.
The range of number display is from 0 to 1000 showing the measured signal in live
time. FE is the ferrous and NE the non ferrous metal measured. The non ferrous
metal is been shown in reduced form above the numbers. Below the numbers the
common metal signal is displayed by a bargraph. On the left of the display you will
see the spectrum of measured signal. With help of the spectrum on basis of 9 spec-
tral lines you are able to do an additionally analysis.
Below the ractagle lines there is a line showing parameters which can be changed
online. Also in this line short information are being shown. The last line shows the
actual menue of the pushbuttons. The detector is ready for working immediately, but
it will take 1-2 minutes until coil battery and electronic are termally stable. By pressing
the pushbutton “REFERENZ” the momories are loaded new and set by factory pa-
rameters. All driftings will be compensited. If you do a reference above a metal ob-
ject, this object also will be compensited and can not be detected any more.
Seite 11 von 31
