9 of 3
○
,11 —— Line Output Selector Switch
Mainly used to select the output audio of current partition;
Note: the current selection of the user can be checked via the interface of PAVA6000. When it is
required to change different audio output, it can only be selected from the panel.
○
,12 —— ON/OFF Selection of Partitions (Partitions)
If the current partitions are closed, they shall be all opened (ON); if the current partitions are all opened, they
shall all be closed (OFF).
○
,13 —— Speaker Partition Status Indicator
Yellow – indicating there is a change of impedance of Speaker A or Speaker B or the current partitions A or B,
which may cause the open circuit or short circuit;
Die-out (OFF) – indicating that the change of speaker circuit impedance of current partitions is within the
impedance range during the modeling of speaker partitions;
Note:
it is required to conduct an impedance method calibration to obtain the impedance value of current speaker
circuit before the host or extended host is wired into the system. The method is as follows:
Pull down the seventh bit of rear row ID switch of the host until you hear the alternate beeps of the buzzer or see the
flash of FAULT Indicator Light on the panel before pulling up the seventh ID switch. When the impedance variation of
speaker circuit exceeds the ± 10-30% of impedance value acquired by the current host or extended host, the current
variation will then be recorded and it will be informed to the user in the form of sound and light. The detection
sensitivity of partitions /partitions is equal to or greater than 20W.
14 —— Partition PTT or Remote Business Microphone Paging Indication
Note: for a paging service, the user can manually close the partitions that are not call or increase the new
partitions.
15 ——Indication that the Partition is Broadcasting “EVAC” Voice Message
Note: the user can manually close the partitions that are not call or increase the new partitions.
16 —— Indication that the Partition is Broadcasting the Background Music
Tip: it is required to select the audio before selecting the output partitions while manually playing the voice
message. For example, if you want to output the audio of Line 3 to the Partition 3, you can select the partition before
selecting the audio, or you can select the audio before selecting the partition. Of course, the final outcomes are the
same. In general, it is habitual to select the partition before selecting the audio. In such a way, various partitions will
output the audio simultaneously, and in addition, it can be operated in the partition control interface of PAVA6000.
17 —— Partition Selection Key
Notes:
1. If one of the current partition output indicator lights “PAGING”, “EVAC/ALERTA” or “BGM” is ON, it will close the
output of current partition by pressing this key;
2. If none of the current partition output indicator lights “PAGING”, “EVAC/ALERTA” or “BGM” is ON, one of them will
be ON by pressing this key (The corresponding LED light is ON according to the current output audio).
