27 of 3
Note
: Please maintain the computer and the EVAC system host in the same network segment before the login in the
PAVA6000.
①
use the static IP address connection method (pull off the fifth bit in the rear-row SWITCH ID setting of PAVA6500
host):
find the icon
in the lower right corner of your computer (the icon may be different for different operating
systems, so please refer to the actual icon), click the right mouse button to select “Open Network and Sharing Center”,
and then select " Change adapter settings " in the pop-up window, as shown in the following figure:
In the pop-up window, select the network connection for current communication (there are maybe many network
connections for the interface of user, so please select the network connection communicating currently with the host).
Click the right mouse button to select “Properties” and find Item “Internet Protocol Version 4(TCP/IPv4)” in the listbox,
and then click the “Properties” in the lower right corner for modification and finally click the “OK”.
②
When the user computer uses the dynamic ID address, the operation method is as follows (if the connection is failed,
it may be caused by the limitation of router of the user. In such a case, please refer to the above method 1):
Pull On the SWITCH at the rear row of PAVA6500 host;
The host is connected through the cable network to “LAN” port of the router connected by the user computer. In
such a case, the host will automatically apply for a legal IP address to the user router.
a.
Default Network Parameter of the Host:
IP address:
192.168.1.168
Sub mask
:
255.255.0.0
Default gateway:
192.168.1.1