DSE Model 5510 Autostart Control and Instrumentation System Operators Manual
057-015 5510 OPERATING MANUAL ISSUE 11 07/07/09 AM 37
5.4 ACCESSING THE FRONT PANEL CONFIGURATION EDITOR
This configuration mode allows the operator limited customising of the way the module operates.
Operation
Detail
To enter the ‘configuration mode’ press both the INFO
and STOP buttons together.
+
5.4.1 ENTERING THE CONFIGURATION EDITOR PIN NUMBER
The configuration editor contains two sections.
•
Main configuration editor (for ‘site adjustable’ or ‘commissioning’ parameters)
•
Application editor (to allow installation engineers to make application changes).
The ‘Application Editor’ is designed to allow the module to be configured for different
applications without needing to re-configure the module settings. This makes it particularly
suitable for applications where the generator would be used in a number of different roles,
specifically in Rental or mobile type applications.
If the module PIN number has been set, the PIN number request is then shown. The configuration
cannot be viewed or changed until the PIN number is correctly entered.
Enter either the ‘main’ PIN or the application PIN.
If no PIN has been set, then skip to the next section.
NOTE:- The ‘Application Editor’ must be enabled first in order to make it accessible from the
module’s fascia. This is done by setting a PIN (number) for the module’s main front panel editor,
using the 5xxx for Windows™ PC configuration software.
Enter pin
The first * is flashing. Press + or – buttons to adjust it to the correct
value for the first digit of the PIN number.
Press
when the first digit is correctly entered.
*
*
*
****
***
***
***
Enter pin
The second * is now flashing. Press + or – buttons to adjust it to the
correct value for the second digit of the PIN number.
Press
when the second digit is correctly entered.
1
1
1
1*
*
*
***
**
**
**
Enter pin
The third * is now flashing. Press + or – buttons to adjust it to the
correct value for the third digit of the PIN number.
Press
when the third digit is correctly entered.
12
12
12
12*
*
*
**
*
*
*
Enter pin
The fourth * is now flashing. Press + or – buttons to adjust it to the
correct value for the fourth digit of the PIN number. Press
when
the fourth digit is correctly entered.
123
123
123
123*
*
*
*
NOTE:- When
is pressed after editing the final PIN digit, the PIN is checked for
validity. If the number is not correct, the editor is automatically exited. To retry you must re-
enter the editor as described above.
