LPV1200 DUO SYSTEM
Page 25 of 40
Ⅺ
.Operation instructions and steps
This type of machine can carry out single-side cold and hot lamination work and double-side
lamination work as well. Sheet and roll films can be used.
(I). How To Do Continuous Cold Laminating Work:
1.
Adjustment of the fabrication forces of the film roll:
After putting the mandrel into brackets, pull the adhesive film with hands for proper
resistances. If fail in reaching the purpose, do it again with the limit collars.
2.
Feeding Films
(
please refer to Figure 10
)
1)
Lift up the rear roller (with no need to use the rear roller for cold lamination).
2)
Turn the pressure-adjust hand-wheel to lift up the front upper roller and feed the film through
between the two rollers and then lay it on the rear working panel;
3)
Pull the adhesive film flat with proper force, turn the pressure-adjust hand- wheel to lower
down the front upper roller, and turn the hand-wheel till there is no gap----that means to
make it to a pressure-free position.