LPV1200 DUO SYSTEM
Page 30 of 40
140°F.
5. Step the pedal switch and feed text and drawings in between the two rollers. Please press
the switch to “Continue” and loosen the pedal switch to complete the continuous
laminating process.
Note:
▲
Feed text and drawings in between the upper and lower rollers while keep text and
drawings trim and the front end of text and drawings will be fed in, so as to avoid
declining or crinkling during operations.
▲
Temperature is proportionate to speed. Don’t adjust the temperature and speed
to the maximum at one time; otherwise the quality of laminating film could be
affected.
▲
During the laminating operations, please observe the effectiveness of the
laminating film. If the thermo-sensitive glue on the surface is not melt completely,
the temperature should be increased (or reduce the speed); if the text and
drawings distorts after the laminating operation, the temperature should be
reduced (or increase the speed).
▲
If there are clear wrinkles on adhesive films or text and drawings, you should
stop the machine, cut off the text and drawings, pull the film straight and feed the
text and drawings in again for laminating .
