LPV1200 DUO SYSTEM
Page 27 of 40
between the two rollers. After that, press “Continue” and let go the pedal switch to complete
the work.
Note:
▲
The text and drawings should be fed between the upper and lower
rollers with trimness and the front end of the text and drawings should
be fed in at the same time so as to avoid crinkling the text and drawings
during the operation.
▲
The text and drawings should be wider than the
adhesive
films so as to
avoid staining the
rollers.
(
Ⅱ
)How To Do Continuous Single Side Laminating Work With Thermal
Sensitive Adhesive Film:
The OPP film should normally be used as the materials for single-side laminating, which
features that there is no backing paper and there is thermo-sensitive glue on the rollers’ surface
and the laminating film needs a high temperature. The laminating quality of this machine during
operation mainly depends on the surface temperature of rollers, the speed, and the melting
temperature for the thermo-sensitive glue on the film surface and ambient temperatures, etc.
Thus we should pay attention to the control of the above-mentioned factors during the
operations.
Film rolls are used for single-side cold laminating:
1. The adjustment of fabrication force for Film rolls
Having put the mandrel with adhesive film into the brackets, you should pull the
adhesive film with proper force to fell a resistance. If not get the required result, you
should try the damp collars.
▲
Note: If the adhesive films are not tightened, the orientation collars for the
roller should be adjusted to increase the fabrication forces.
2. Feeding Films (shown as figure 11):
Turn the pressure-adjust hand-wheel to lift up the front upper roller and put the adhesive film on
the edge of operating panel and through the two rollers, put slip sheets on the lower front end of
film between the two rollers (the slip sheet should be wider than the film), pull the film tight
with some force, turn the pressure-adjust hand-wheel to take down the front upper roll and put
