Dräger Medical Babytherm 8004, Техническая документация инструкция

Страница: 66 / 110

All right
s re
served.
Copyright reserved.
V
e
rsi
o
n
2
.1_
R
e
le
ased
_P
ri
n
ted
on
_2
8.0
3.0
6
_
K61
32
300
V0
1.f
m
60
6132.300
Maintenance Procedures Babytherm 8004/8010
2 Nightlight
2.1 General information
about the nightlight
The small energy-saving lamp (nightlight) of the radiant heater must be
replaced if it is faulty.
2.2 Dismounting/replac-
ing the nightlight
• Plug the Babytherm power cord into the mains socket-outlet.
• Set the electrical height adjustment (option) of the Babytherm to the low-
est position.
• Unplug the Babytherm power cord from the mains socket-outlet.
• Swivel the radiant heater in your direction.
• Remove the faulty energy-saving lamp 1 (nightlight) by holding the lamp
mount 2 and by turning the energy-saving lamp counter-clockwise.
Fig. 2:
Radiant heater actuators (underside); removing the nightlight.
• Fit the new energy-saving lamp 1 (nightlight) by holding the lamp mount 2
and by turning the energy-saving lamp clockwise (hand-tight).
• Plug the Babytherm power cord into the mains socket-outlet.
• Switch the Babytherm on.
• Press the nightlight button on the control unit.
The small energy-saving lamp (nightlight) on the radiant heater comes on.
WARNING
Risk of burns! The infrared rods or the protective screen may cause
burns if touched shortly after use of the radiant heater. Allow the radi-
ant heater to cool off for at least 15 minutes before servicing.