Requirements:
The spray gun has been put into opera-
The electrostatic controller is switched
on.
Fig. 22: Guide the spray gun
1. Guide spray gun as follows:
Guide spray gun at 90 degrees to the
surface.
Maintain a distance of 15 to max.
25cm to the surface.
The distance can vary for effect
coatings.
6.7
Rinsing
6.7.1 Safety recommendations
NOTICE!
Material damage due to unsuitable
rinsing agent
If the rinsing agent reacts chemically with
the components or the material, compo-
nents get damaged.
– Use only the rinsing agents that are
compatible with the components and
the material.
– Refer to safety data sheet of material
manufacturer.
6.7.2 Rinsing spray gun
NOTICE!
Clogged air channels
If the material or rinsing agent reaches
into the air channels, air channels can clog
up. This can result in faulty painting
results.
– Keep spray gun horizontal or directed
downwards during the rinsing process.
Rinse the spray gun in the following cases:
After end of operation
Before every change of material
Prior to cleaning
Prior to dismantling
Before a long time of non-use
Before placing in storage
Operation
11/2019
EcoGun AS MAN EC - MSG00022EN
16/52
