7.
Screw in the mounting plates with galvanized lag
or countersunk screws M6 according to DIN 7991
and DIN 7997.
8.
Remove all assembly blocks.
Fig. 53
7.
8.
Mounting the double action hinge onto the wall
4.3 Frame with embedded
mounting plate
4.3.1 Check the glass door leaf
CAUTION
Risk of injury from broken glass
Cutting/cutting off the fingers on sharp
parts of broken glass.
Wear protective gloves.
1.
Check the glass door leaf for damage, e.g. glass
for conchoidal fractures and/or damaged edges.
Do not install damaged glass door leaves.
2.
Check the dimensions of glass preparation, see
Fig. 44 on p. 16.
4.3.2 Preparing the door frame
1.
Vertically mark the recesses for the mounting
plates in the frame. Dimensions A and B see Fig.
44 on p. 16.
2.
Cut out 4 mm deep recesses for the mounting
plate in the frame.
Fig. 54 Dimensional drawing for mounting plates recesses in
the frame
4.3.3 Prepare the double action
hinge
1.
Disassemble the counter plate (Fig. 55/1).
2.
Select the appropriate gaskets (Fig. 55/2)
according to the glass thickness (see Table in
Chapter 4.1).
3.
Peel off the protection film of the adhesive tape
on the base and counter plate (Fig. 55/1 and Fig.
55/3).
Fig. 55
2.
3.
1.
1
2
3
Preparing the double action hinge
4.
Fix the gasket onto the base and counter plate.
4.3.4 Fix mounting plates
1.
Place the countersunk screws M8 x 16 into the
prepared counterbore of the mounting plate.
2.
Fasten the mounting plate with four countersunk
screws (M6 x 12) to the TENSOR double action
hinge. Tightening is 12 Nm.
Fig. 56
2.
1.
Attaching the mounting plates to the double action
hinge
19
TENSOR
2017-11
WN 059361 45532
dormakaba Mounting instructions
Mounting
