![Doosan DV11 Скачать руководство пользователя страница 6](http://html1.mh-extra.com/html/doosan/dv11/dv11_operation-and-maintenance-manual_2521420006.webp)
DV11
Operation and Maintenance
3
Safety regulations & specifications
Printed in Mar. 2005 PS-MMA0608-E1A
z
When the engine is hanging on a crane, no-one must be allowed to stand or
pass under it. Keep lifting gear in good condition.
z
When do electric weld, stop the engine, power off, then remove the wire
harness’ connector which is connected to the ECU.
z
Do not weld the electric control unit (ECU) absolutely, and do not damage on
it by electrical or mechanical shock.
z
When working on the electrical system disconnect the battery earth cable
first. Connect it up again last in prevent short circuits.
1.1.3. To prevent damage to engine and premature wear
(1) Never demand more of the engine than it was designed to yield for its intended
purpose.
Detailed information on this can be found in the sales literature
. Engine control
unit must not be adjusted without prior written permission of DOOSAN.
(2) If faults occur, find the cause immediately and have it eliminated in order to
prevent more serious of damage.
(3) Use only genuine DOOSAN spare parts. DOOSAN will accept no responsibility
for damage resulting from the installation of other parts which are supposedly
"just as good”.
(4) In addition to the above, note the following points.
z
Never let the engine run when dry, i.e. without lube oil or coolant.
z
Pay attention to cleanliness. The Diesel fuel must be free of water.
z
Use only DOOSAN approved service products (engine oil, anti-freeze and
anticorrosion agent)
z
Refer to the subjects of recommendation of the fuel.
z
Have the engine maintained at the specified intervals.
z
Do not switch off the engine immediately when it is warm, but let it run without
load for about 5 minutes so that temperature equalization can take place.
z
Never put cold coolant into an overheated engine.
z
Do not add so much engine oil that the oil level rises above the max. marking
on the dipstick. Do not exceed the maximum permissible tilt of the engine.
z
Always ensure that the testing and monitoring equipment (for battery charge,
oil pressure, coolant temperature) function satisfactorily.
Downloaded from
www.Manualslib.com
manuals search engine