DOLD SAFEMASTER PRO UG 6951, Руководство пользователя

Страница: 22 / 60

Configurable safety system SAFEMASTER PRO - Fieldbus module
22
0265998 / 16.05.19 de / 101A
SOFTWARE BUS CONFIGURATOR
The fieldbus module is configured via the micro USB interface on the front panel and using the "BUS
CONFIGURATOR" software on the SAFEMASTER PRO Designer CD-ROM.
This software allows configuring all fieldbus modules. It allows also the bi-directional communication of the
SAFEMASTER PRO system with a PC (using fieldbus module UG6957 for USB) or the display of the data, that
is transferred on the IN-RAIL-Bus of the SAFEMASTER PRO System (via the USB Port of the fieldbus modules).
The following picture demonstrates the possible connections
It is important to point out the difference in behaviour oft the BUS CONFIGURATOR when communicating with
the modules UG 6951 to UG 6959 and the module UG 6957 (USB):
• Module UG 6951 to UG 6959: The software only allows the display of data that is transferred on the IN-RAIL
Bus.
• Modul UG 6957: The software allows the bi-directional data transfer. In this case the operator can set the
state of the inputs “Fieldbus Input” directly from the computer.
The configuration data depend on the type of the fieldbus module that is connected:
The address field range and the baudrate data will adapt to the fieldbus type.
 The module must be configured with the outputs disabled (outputs OFF)
The address range depends on the type of fieldbus that is installed.
Module configuration can be queried at any time during module operation.
To configure the fieldbus module, proceed as follows:
1. Connect the module via the IN-RAIL-BUS to the SAFEMASTER PRO system
2. Connect the SAFEMASTER PRO system to the 24VDC +20% voltage power supply via the terminal strip;
ATTENTION
: the master unit UG 6911.10 must be without error state
3. Connect the USB cable to the PC and to the fieldbus module;
4. Start up the "
BUS CONFIGURATOR"
software.