DNP CL-500, Руководство по обслуживанию

Страница: 29 / 60

25
SET UP GUIDE
SET UP GUIDE
CL500 series Card Laminator is using heat press roller system to the surface of the card. It is important to do best setting
to securing sufficient adhesive strength and minimum warp of the card, by heating occurs at the time of lamination. This
guide explains the method of a set up in the case of laminating on the card which is printed by CX-320 (CX210 ans CX-3**
series) or CX-120 (CX-1** series). The situation which the warp of the card is generated is different respectively according
to the card. Please have an evaluation enough for prior use referring to this guide when using the Laminator.
The setting value indicated to this guide is a reference value to the last, and does not guarantee a performance.
Please acknowledge not securing about the fault by the poor adhesion by the characteristic of the card and
trouble by the card warp.
1. SETTING OF LAMINATE CONDITION
(1) Default Values
Among items that can be set in User Mode and Service Mode, those related to the laminating performance and the
default values are indicated below. Regarding to the detail of items, refer to section 3. Various Conditional Settings.
*Service Mode is a set mode only for the dealer and serviceman.
Connect with CX-320 (CX210 and CX-3** series)
No Mode Item Default Values Remarks
1 User Mode Film 1mil 0.6mil Overlay Select film type.
2 Temp 170°C 155°C 130°C Default value of the heat roller surface
temperature is tide to Film selection.
3 Speed 5.5mm 8.5mm 8.5mm Default value of the speed of the card
/sec /sec /sec during laminating is tide to Film selection.
4 Card Fan Half Off Off Card cooling fan during laminating
5 Cooling Time 0sec Card cooling time before laminating
6 Service Temp + Gain 2 Temperature gain at low temperature.
7 Mode Temp - Gain 1.5 Temperature gain at high temperature.
Connect with CX-120 (CX-1** series)
No Mode Item Default Values Remarks
1 User Mode Film 1mil 0.6mil Overlay Select film type.
2 Temp 160°C 145°C 130°C Default value of the heat roller surface
temperature is tide to Film selection.
3 Speed 5.5mm 8.5mm 8.5mm Default value of the speed of the card
/sec /sec /sec during laminating is tide to Film selection.
4 Card Fan Half Off Off Card cooling fan during laminating
5 Cooling Time 0sec Card cooling time before laminating
6 Service Temp + Gain 2 Temperature gain at low temperature.
7 Mode Temp - Gain 1.5 Temperature gain at high temperature.
The values in the above list are decided as the fastest operation speed and getting minimized card warp. Each kinds of
cards shall have different condition in the best suited, please have an evaluation enough for prior use.