DMP Electronics 1100T, Инструкция по установке и программированию

Страница: 9 / 24

Digital Monitoring Products, Inc. | 1100T Wireless Translator Installation and Programming Guide 5
Program Device Setup
The translator must first be programmed as a device in Device Setup. Zones should
be programmed in Zone Information.
1. Go to DEVICE SETUP and press CMD .
2. At DEVICE NO , enter the desired device number for the 1100T. Available addresses:
• XT30, XT50, XTL Series, or XR150: 2-8
• XR550: 2-16
3. Select
*UNUSED*
to enter a name for the device. After naming the device,
press CMD .
• XR Series Panels:
Press the fourth select key or area to change the device type.
Press CMD until TLR is displayed and select that for the translator.
• XT Series Panels:
At 1100T? NO YES , select YES and press CMD .
4. Enter the Serial number.
5. At
1100T FREQ , press any select key or area to select the non-DMP system.
Default is HWL (Honeywell).
6. At SUPRVSN TIME , select the supervision time required for the 1100T. DMP
default supervision time is
240
minutes.
7. Press
CMD
and then the Back Arrow to exit Device Setup.
2