4
1100T Wireless Translator Installation and Programming Guide | Digital Monitoring Products, Inc.
INSTALL THE TRANSLATOR
Wire the Power Supply
The 1100T Wireless Translator can be powered from a 12 VDC external power supply.
In addition to powering the translator, the power supply also charges the back-up
battery. If the DC power source is removed, the power failure is indicated as an open
condition on the translator device number.
The 372-500-W power supply must be located within 100 feet of the translator using
22 AWG wire. Use the following steps to connect it:
1.
With the cover removed, connect the positive wire to the positive terminal on
the translator.
2. Connect the negative wire to the negative terminal on the translator.
3. Plug the power supply into a wall outlet not controlled by a switch.
1
PRE-INSTALLATION
Before installing the translator, the DMP panel and receiver must already be powered on
and set up in their final locations. See the panel and receiver guides for their installation
information.
Содержание 1100T
Страница 1: ...INSTALLATION AND PROGRAMMING GUIDE 1100T Series Wireless Translator ...
Страница 2: ......
Страница 4: ......
Страница 24: ...LT 2243 1 01 21132 2021 Digital Monitoring Products Inc ...