DMP Electronics 1100T, Инструкция по установке и программированию

Страница: 14 / 24

10 1100T Wireless Translator Installation and Programming Guide | Digital Monitoring Products, Inc.
XT Series Panels
1. Reset the control panel by placing and removing a jumper on RESET .
2. From the keypad, enter 8144 (WALK).
3. Select STD to test all programmed zones.
4. Once in the Walk Test, walk around and trip each protective device. Continue
tripping devices until the entire system is tested.
• Each time a selected zone trips, the keypad buzzes and the bell rings
for two seconds.
• Each time a
FI
,
FV
,
SV
, or
CO
zone trips, a Sensor Reset occurs.
5. Press the select key or area directly below END to stop the Walk Test.