9024-066-A-1-15
21
OFF
RESET
ALARM
MANUAL RELEASE
2.2 Power Select Jumper and Turning Power ON
The
“POWER SEL”
jumper on the circuit board
MUST
be set correctly or operator will not function correctly.
The operator manages the power drain of the circuit board
by powering down unused inputs on the board when the
operator is idle. When the gate has been closed for 5 min.
or held open for 5 min., the circuit board powers down unused inputs to conserve power drain.
Main terminals 1, 2, 3
and
loop detector
ports
NEVER
power down. Any activation from one of these inputs will power up the circuit board when it is in the powered down mode. It is
important to have low current draw devices connected to these specific inputs or operator performance will be
significantly reduced
.
1234567
8
ON
12345678
ON
1 2 3 4 5 6 7 8 9 10
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
EXIT
LOOP
REVERSE
LOOP
AC POWER/SOLAR
POWER SEL
REV SENSE
P3
SELF TEST
RESET
RED=CHARGING
GREEN=CHARGED
KEY
SWITCH
NO
NC
3 BUTTON
CONTROL
SW1
SW2
OFF
ON
POWER
P4
P2
1
6
TIME DELAY
12345678
ON
1 2 3 4 5 6 7 8 9 10
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
EXIT
LOOP
REVERSE
LOOP
AC POWER/SOLAR
POWER SEL
REV SENSE
P3
SELF TEST
RESET
RED=CHARGING
GREEN=CHARGED
NO
NC
3 BUTTON
CONTROL
SW2
OFF
ON
POWER
P4
P2
1
6
TIME DELAY
DO NOT
cycle the operator until the “
DIP-Switches”
and the “
Limit Switches”
have been adjusted.
Damage could occur to the gate and gate operator.
See pages 23-25.
DC Power
Switch
KEY
SWITCH
Battery Charging
LED Monitor
OFF
ON
To power up operator
:
turn DC power
switch
ON
. Press
KEY SWITCH
and
LEDs will light up on circuit board.
Important Battery Plug Note:
Battery Plug P2 comes from
the factory unplugged and
needs to be plugged into
circuit board when operator
is ready to be powered up.
Loop Detectors:
DoorKing’s low
current draw plug-in loop detectors
are specifically designed to be
connected to a solar powered gate
operator.
If using a third party external loop
detectors, they
MUST
be a low current
draw type.
Radio Receiver:
DoorKing’s 3-wire
radio receiver is specifically designed
to be connected to a solar powered
gate operator. If using a third party
radio receiver, it MUST be a low
current draw radio receiver type.
This may be red when first powering up
operator depending on how much of a
charge the batteries have.
Battery
Plug P2
Power Management of Circuit Board
POWER SEL Jumper
RED=CHARGING
GREEN=CHARGED
RED=CHARGING
GREEN=CHARGED
Power is limited to 250 mamps.
3-Pin Remote Terminal
1
2
3
Important:
Pins 2 and 3
MUST
be jumpered together
when using solar input power to
manage power drain
from circuit board.
DO NOT
jumper pins 1 and 2 together or circuit board
will not manage power and
continually draw FULL
power
from the batteries.
AC POWER / SOLAR
POWER SEL
1
2
3
Constant Power
Constant Power
Constant Power
Constant Power
Constant Power