DKS 1833 Series Скачать руководство пользователя страница 28

Страница: 28 / 70

1835-065-J-7-14

3.2 Set-up Telephone Entry System for PC Programming

Beginning in January, 2010, all DKS 1830 series telephone entry systems come standard with

3000 memory (APB - anti-pass

back) chips installed in the system.

The information below is to assist you with programming older systems or when there is a

need to change the memory chips to match a chip set on another system already installed.

Prior to starting the programming

of the PC programmable telephone entry system, you must know the memory capacity and type of the EEPROM chips that
are installed in the unit.

This can be determined by inspecting the small chip that has a tag

listing the memory size on it and will be labeled APB if anti-pass back is enabled. The memory
size determines the number of residents, vendors, four-digit entry codes and device codes that
can be stored in the system. APB indicates that the chip set has anti-pass back capability. The
table shows the valid numbers available with each memory level.

If you need to remove and replace the chips, see Section 1.5 Memory Chip Replacement.

3.1.3 System Memory Chip Identification

RING

CLK

SEN

SPK

VOL

FEED

BACK

RS 232

ELEVATOR

MIC

VOL

OFF

KEYPAD

3 2 1

MASTER
CODE

16AC

BAT

1NO

1NC

2RY

IMC

5VDC

IMD

SPKR

COM

MIC

PSW

CGND

PHONE

Chip Locations

System Keypad

Chip Part Number

Standard

APB

1835-150
1835-151
1835-152
1835-153
1835-154
1835-155
1835-156
1835-157

1835-140
1835-141
1835-142
1835-143
1835-144
1835-145
1835-146
1835-147

System

Memory

25
75

125
250
500

1000
2000
3000

Phone Number

Capacity

25
75

125
250
500

1000
2000
3000

Name

Capacity

25
75

125
250
500

1000
2000
3000

Entry Code

Capacity

25
75

125
250
500

1000
2000
3000

Device Code

Capacity

625

1875
3125
6250
8000
8000
8000
8000

Prior to using a PC to program this PC Programmable Telephone Entry System with the DoorKing Remote
Account Manager for Windows software, the programming steps in section 3.2.1 through 3.2.8 factory
settings

MUST

be reviewed or re-programmed if necessary (most factory settings are typically desired).

There is no need to re-program these settings unless you want to change them. For easy reference, refer
to the chart on page 29 that list the various programming functions and their factory default settings.

Section 3.2.1 through 3.2.8 can ONLY be programmed from the System Keypad. There is NO program-
ming sequence in the Remote Account Manager Software to program these features with.

This programming step sets the system

MASTER CODE

. The master code is the four-digit number

REQUIRED

to gain access to

the system memory.

You need to know the master code prior to programming the system with the PC, or to perform ANY of

the programming functions on the following pages. It MUST be programmed in from the system keypad.
NO Factory setting -

Each entry system’s master code

MUST

be unique.

See section 4.5 for more information about the master code switch.