DITECH DT5638, Инструкция по эксплуатации

Страница: 39 / 52

DEU
ENG
39
ENG
Commissioning
5. For stone walls, drill the holes at the marked positions with a 5 mm masonry drill.
6. Insert dowels into the bores.
7. Install the installation bottom using the supplied screws (see fig 2a page 4).
8. Position the device onto the installation bottom and latch it in (see fig 3 page 5).
5.2.2 Installation in flush-type box
The fixing holes on the installation bottom can be used for installation on a flush-
type box (see fig 2b page 4).
1. If necessary, release the device from the installation bottom with a suitable
screwdriver (see fig 3 page 5).
2. Align the installation bottom horizontally on the flush-type box.
3. Install the installation bottom with suitable screws (see fig 2b page 4).
4. Position the room control unit Display onto the installation bottom and latch it
into the clips (see fig 3 page 5).
5.2.3 Installation with adhesive strips
Depending on the ground, installation can be performed using the supplied dou-
ble-sided adhesive tapes. Installation is possible on different grounds, as e. g. ma-
sonry, furniture, tiles or glass.
If the installation is done with adhesive strips, the installation surface must
be smooth, level, undamaged, clean, and free from grease and solvents.
1. Select an appropriate installation position.
2. Remove the protective foil from one side of the adhesive strip.
3. Fix the adhesive strip on the back side of the installation bottom in the recesses
provided for this (see fig 2c page 4).