Directed VW02, Руководство специфичное для прошивки, Страница: 5 / 43

5
Directed Digital System VW02
© 2016 Directed. All rights reserved.
Wiring connections
The wiring connections listed below are specific to this firmware.
Main power harness (H1), 12-pin thick gauge connector
Conn./Pin Color Description
H1/1 White Relay 3 COM – (+) 12 Volt (Battery)
1
H1/2 White/Brown Relay 3 N.O. – (+) Ignition Output
1
H1/3 Brown/Red Relay 2 N.O. – Key Wrap
H1/4 Yellow/Red Relay 2 COM – Key Wrap
H1/5 Orange/Red Relay 2 N.C. – Key Wrap
H1/6 Yellow Relay 1 COM – Clutch (Manual Transmission ONLY)
1
H1/7 White Relay 3 COM – No Connection
1
H1/8 White/Brown Relay 3 N.O. – No Connection
1
H1/9 Black (-) Ground
H1/10
Red (+) 12 Volt (Battery)
H1/11 Orange/Yellow Relay 1 N.C. – Clutch (Manual Transmission ONLY)
1
H1/12 Brown Relay 1 N.O. – Clutch (Manual Transmission ONLY)
1
Auxiliary output harness (H2), 16-pin black connector
Conn./Pin Color Description
H2/1 Violet/Brown Door Locks
H2/2 Yellow/Black No Connection
H2/3 Orange/Black (-) Clutch Output
H2/4 Tan HS CAN Low
H2/5 Tan/Black HS CAN High
H2/6 Light Green No Connection
H2/7 Orange/Green FT CAN High
H2/8 Orange/Brown FT CAN Low
H2/9 Violet/Green Door Locks
H2/10 Green/Black (-) Hazards Switch Output
2
H2/11 White/Violet No Connection
2
H2/12 White/Red (+) Accessory Output
2
H2/13 Lt. Blue/Black (-) PTS Output
2
H2/14 Green/Red (+) Brake Activation Output or (+) Starter Output
2
H2/15 N/A No Connection
H2/16 Violet/Yellow No Connection
1. If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed.
2. If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are
low current and a relay may be necessary.