Directed VW02, Руководство специфичное для прошивки, Страница: 29 / 43

29
Directed Digital System VW02
© 2016 Directed. All rights reserved.
External commands
LED Description Troubleshooting Comment
Flashes green
x 1
LOCK command
received.
If the bypass module fails to flash, it means the
module did not receive the signal.
Commands can come from RF, D2D or
W2W.
Flashes green
x 2
UNLOCK command
received.
Flashes green
x 3
TRUNK command
received.
Module reset
A module reset will only erase the steps perfomed in "Module programming" on page 26. All settings
(firmware) and settings flashed to the module using the web configuration tool will not be affected.
1
If required for your installation, connect both black 16-pin and white18-pin
harnesses, as well as the white 7-pin harness to the module. Press and hold the
programming button, then connect the white 12-pin harness to the module.
1
st
4
th
3
rd
2
rd
5
th
2
Wait 3 seconds until the LED turns ON solid orange then release the
programming button. The LED turns ON solid red.
Solid Solid
& &
Release
Hard reset
Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some
settings may need to be reconfigured. Connect your module to a computer and use the web configuration tool to
edit its programmable features.
1
If required for your installation, connect both black 16-pin and white 18-pin
harnesses, as well as the white 7-pin harness to the module. Press and hold
the programming button, then connect the white 12-pin harness to the module.
1
st
4
th
3
rd
2
rd
5
th
2
After 3 seconds the LED turns ON solid orange. Keep holding the
programming button until the LED flashes red, then orange slowly.
Hold Flashes Solid
& &
3
Release the programming button. The LED turns ON solid red.
Solid
&
Release