Direct PDCXX50IR, Инструкция по установке и настройке

Страница: 41 / 92

35
H.264 Video Surveillance System Setup Guide
SECTION 5: NETWORKING YOUR DVR
d. Examine the screen capture shown above. If the response to the ping command was “ Request timed out . ” like that
shown above, use this IP address for your DVR, enter into Table 1, skip step 2.e and continue at step 2.f.
If the response to the
ping
command was “
Reply from 192 .168 .1 .100
: ..” as shown below, a device exists on the
network that is using this IP address. If so, continue at step 2.e.
e. Since the response to ping test returned a reply as shown above, try the ping with another number between 1 and 255
until one is found that responds with the “ Request timed out . ” message. Use this IP address with your DVR and enter
it into Table 1.
f. In table 1, copy the PC’s Subnet Mask and Default Gateway entries into the DVR’s
Subnet Mask
and
Default Gateway
cells.
3. At your DVR, click the
System Settings
icon on the Tool Bar. The SYSTEM tab window will open.
System Settings
4. Click NETWORK to open the NETWORK settings menu.
NOTE
The default IP addresses and port settings of your DVR may be different from those shown in this document. Always use
network settings that are compatible with your network(s).