Dion-Ag Scorpion 300, Руководство оператора

Страница: 28 / 109

SETUP
28
STEP 5
Center the extension (item 3) with the draw bar (item 4). To center side to side, use the bolts (item 11).
STEP 6
Insert pin (item 14) and lock with the safety pin (item 15). Note that items 14 and 15 are not supplied by the
manufacturer.
STEP 7
Install the safety chain (item 16) between the tractor frame and the Forage Harvester. Refer to page 27 for
more information on how to install the safety chain.
Figure 19 Cat. II drawbar extension
FOLLOW THESE INSTRUCTIONS TO INSTALL A CAT. III AND IV DRAW BAR EXTENSION:
Refer to Figure 20 for the following steps:
STEP 1
Insert shims (items 1 and 2) inside extension (item 3). Insert extension with shim inside the draw bar
(item 4). You need at least the thickness of one shim (item 2) to clear the bolt head.
STEP 2
Insert two stove bolts (item 6) through the shims as shown below. Insert bolts (item 6) inside the extension
(item 3) and screw the nuts (item 8) on the stove bolts (item 6). Adjust the shims to eliminate the clearance
between the extension and the tractor’s drawbar, from top to bottom.
STEP 3
Insert pin (item 9) with a safety pin (item 10) inside extension (item 3) and lock with safety pin (item 10). If
the hole in the draw bar is too large, insert a bushing (item 13) in the hole to reduce the clearance with the
pin (item 9));
STEP 4
Screw nuts (item 12) on bolts (item 11) and then screw bolts (item 11) on both sides of extension (item 3) as
shown below.
Manual N o. F6918E003E v1.2