Dinolift DINO 210XTB II, Руководство по эксплуатации

Страница: 50 / 67

50
Operating instructions
•
DINO 160XTB
•
180XTB
•
210XTB
6. FAULT FINDING
FAULT REMEDY
1. Electric motor cannot be started by depressing the start button, although the
selector switch 1 is in position LCB or UCB
The mains switch is turned off Turn on the mains switch.
The emergency stop button is pushed down in
chassis or platform contol centre.
Pull up the button and re-start the motor from the
start button.
No power supply to the main centre - no readout
in the battery gauge.
Check the fuse F3 (10A glass tube fuse in the
main centre).
Check the fuse F12 (15A automatic fuse in the
left battery housing)
Check the fuse FG (150A megafuse in the left
battery housing)
Power supply to the main centre OK - the battery
gauge readout is between 100 % - 1 %.
Check the fuse F1 (10A glass tube fuse in the
main centre).
Check the fuse F4 (10A glass tube fuse in the
main centre).
Power supply to the main centre OK - the battery
gauge readout is 0 %.
Batteries are flat -> recharge batteries by
connecting the mains cable.
2. “Boom up” and “Telescope out” movements are not operational, although the
electric motor starts normally as other movements are operated
Battery voltage low, lifting movements are
impeded.
Recharge the battery by connecting the mains
cable.
3. None of the platform movements operate though the electric motor is running and
the selector switch is in position 2 or 3
Overloading of the boom has occurred.
Retract the platform with the buttons 6 or 21
inside the designated operating range of the
platform (the green light in the platform control
panel lights up).