Dinolift DINO 210XTB II, Руководство по эксплуатации

Страница: 44 / 67

44
Operating instructions
•
DINO 160XTB
•
180XTB
•
210XTB
5.3.2. Driving with the driving device
The hydraulic driving device is intended for moving the lift within the work area if the towing
vehicle cannot be used.
During transfer in rough terrain, try to stay above the machine.
1. Turn the selector switch (1) to position ”chassis control centre LCB”.
2. Start the motor
Honda: set the engine revolutions at 3/4 of the maximum speed.
3. Make sure that the platform is in the transport position and the outriggers are lifted in the
upper position
4. Make sure that the mains cable is long enough to cover the
whole travel distance (power supply from mains).
5. Switch the driving device to the drive position
6. Release the parking brake
7. Drive the lift with the drive controls
DANGER
WARNING
CAUTION
NOTICE
Do not drive the jockey wheel into obstacles or potholes. If one of the wheels bumps
into an obstacle, the lift may turn abruptly.
After driving:
1. Apply the parking brake
2. Disconnect the driving device from the wheel
DANGER
WARNING
CAUTION
NOTICE
Do not extend the jockey wheel too much. It increases the risk of damage.
When moving the lift using the driving device, a suitable length for the jockey wheel’s stem
can be achieved by adjusting the gap between the lower surface of the tow-bar/brake rod
and the wheel to 1-3 cm. Then the wheel may turn freely.
When driving on a slope: