Dinolift DINO 210XTB II, Руководство по эксплуатации

Страница: 46 / 67

46
Operating instructions
•
DINO 160XTB
•
180XTB
•
210XTB
3. Connect the emergency stop wires and light plug to the vehicle. Check the cable for
chafing and proper operation of the wires.
4. Check the operation of the lights.
5. Carefully release the parking brake and make sure that its locking is in order and that its
handle stays in the lower position.
6. Lift up the jockey wheel to the transport position.
Clean and lubricate the ball-coupling regularly.
In particular, if you are parking or disconnecting the lift from the towing vehicle on a slope,
apply the parking brake as firmly as possible. After having applied the parking brake, push
the lift backward to make the reverse automatics release the brake shoes. The spring
cylinder pulls the parking brake tighter, and the brakes of the vehicle will again be properly
engaged.
Adjust the brakes according to the service instructions.
Place chocks under the wheels as an additional precaution.
While towing, in addition to the instructions in this manual, the user must also observe the
road traffic legislation, regulations valid at the work site and towing instructions of the towing
vehicle.
DANGER
WARNING
CAUTION
NOTICE
Always ensure before towing:
• transport position of the outriggers
• locking of the ball-coupling
• operation of the lights, connection of the cable
• that the parking brake is disengaged
• condition and pressure of the tyres
rear axle 450 kPa (4.5 bar)
jockey wheel250 kPa (2.5 bar)
• attachment of the safety wire
• locking of the brakes after the transportation
• locking of the jockey wheel in its upper position
• that the driving device is disconnected from the wheel
• that there is no additional load on the platform
Place chocks under the wheels while disengaging the lift from the
towing vehicle.