Changing DigitalinxIP Encoder and Decoder IP Addresses
The DigitalinxIP IPEXCB control interface automatically assigns IP addresses to encoders and
decoders in an DigitalinxIP system when they are discovered by the IPEXCB. You can change these
auto assigned IP addresses to an address scheme of your choice by accessing the
TX/RX SETTINGS
menu.
Note
: The web browser GUI only offers manual changes to encoder and decoder IP addresses
individually. If you have several encoders and decoders on an A/V network that need to be changed,
it would be advised to make a batch change in DigitalinxIP Configurator.
To change the IP address of the selected device, check the appropriate
IP MODE
option then enter
in the
IP address
,
Subnet Mask
and
Default Gateway
as desired, then click
APPLY
BEST PRACTICE:
It is a best practice to physically label the DigitalinxIP encoder or decoder with the
newly changed IP address so it can be located easily on an A/V network for future use and service.
If you do not remember the newly changed IP address of the DigitalinxIP device and cannot find it
on the A/V network, you will have to perform a factory reset on the device.
To select an encoder or decoder on the A/V network check the button next to the appropriate
device under
DEVICE SETTINGS
. To refresh this list click
RELOAD
.
