Digital Projection E-Vision Laser 10K Series, Инструкция по установке и быстрому запуску

Страница: 75 / 126

page 67
Digital Projection E-Vision Laser 7500, 8500 & 10K Series
Operating Guide
USING THE PROJECTOR
Rev D August 2017
Setup menu continued from previous page
Power On/Off
•
Auto Power Off
Set this to On if you want the projector to go into STANDBY mode when no input
source is detected for 20 minutes.
•
Auto Power On
Set this to
On
if you want the projector to start up immediately when the mains is
connected.
Set this to
Off
if you want the projector to go into STANDBY mode when the mains
is connected. In this case, the projector will not start up until the
POWER
button is
pressed on the control panel or the
ON
button is pressed on the remote control.
•
Scheduled on/off
Access this submenu to create a weekly schedule for automatic on and off times:
1. Set a schedule:
•
Use he
UP
and
DOWN
arrow buttons to highlight a row, then press
ENTER/OK
to enable edit mode.
•
Within a row, navigate with the
LEFT
and
RIGHT
arrow buttons. Set
values with he
UP
and
DOWN
arrow buttons.
•
To exit edit mode, press
ENTER/OK
. Alternatively, press
EXIT
if you don’t
want the changes to take effect. Move to another row using he
UP
and
DOWN
arrow buttons.
2. To enable the schedule, set
Schedule
to
On
.
Notes
Power On/Off
Auto Power On
Scheduled on/off
Auto Power Off
Off
u
Off
Scheduled on/off
On
T
¨ ¨ ¨ ¨ ¨ ¨
12: 34
Schedule Off
Off
T
¨ ¨ ¨ ¨ ¨ ¨
12: 34
On
T
¨ ¨ ¨ ¨ ¨ ¨
12: 34
Off
T
¨ ¨ ¨ ¨ ¨ ¨
12: 34
S M T W T F S
Time