Chapter 1. Digital Unix
EK–SM410–UP. A01
1–13
Figure 1–3 Trilink Connector
5. Remove the maintenance terminal cable (if attached).
6. Loosen the four mounting screws (refer to Figure 1-2) on each side of the front panel
with a medium blade screwdriver.
7. Use a gentle up-and-down rocking motion to loosen the module from the shelf
backplane.
8. Slide the module out of the shelf (noting which rails the module was seated in) and
place on an approved ESD work surface or mat.
1.5.4 Cache Module Removal
1. Use a gentle up-and-down rocking motion to loosen the module from the shelf
backplane.
2. Slide the write-back cache module out of the shelf, noting which rails it was seated
in, and place it on an approved nonconductive ESD mat.
WARNING
Do not allow the write-back cache to contact any
conductive surface, or injury and/or equipment
damage may result.
