Chapter 6. NetWare–PCI
EK–SM410–UP. A01
6–15
If the storageset is a striped mirrorset, the form of the command line is slightly different
than shown.
Example:
HSZ> add stripeset
[name] [mirrorset] [mirrorset]
6.9.4 Enable Storageset Options
View the storagesets just created.
HSZ> show storageset full
Compare all the parameters in the listing with the Storageset Table (Table 6–2). Change
the storageset parameters to be the same as shown in the table using the
set
command
where necessary.
The format of the
set
command for each item in the storageset table is shown below for
easy reference. Use only the entries that pertain to your configuration.
POLICY
HSZ> set [
name] policy=best_performance
HSZ> set [
name] policy=best_fit
HSZ> set [
name] nopolicy
READ_SOURCE
HSZ> set [
name] read_source=least_busy
HSZ> set [
name] read_source=round_robin
HSZ> set [
name] read_source=[uses]
where [
uses
] is a single disk.
COPY
HSZ> set [
name] copy=normal
HSZ> set [
name] copy=fast
RECONSTRUCT
HSZ> set [
name] reconstruct=normal
HSZ> set [
name] reconstruct=fast
AUTOSPARE
HSZ> set failedset autospare
HSZ> set failedset noautospare
Note that the unit (“USED BY” column) will be assigned in the next subsection. Also,
the existing chunksize will be maintained in the new controller. The chunksize cannot be
changed because you cannot use the “initialize” command.
