Page 23
-
H2: Estimated height over next WP.
-
HA: Estimate height over goal.
3.3.1
BAROMETRIC ALTIMETER (A1)
On the Thermal Display page the A1 altimeter (barometric
altimeter) is the first altimeter shown (highlighted here in red).
In order to synchronize the A1 altimeter (barometric altimeter) with
the GPS altitude, the GPS unit must be turned “ON” and a GPS
“FIX” made.
To turn “ON” the GPS, press the
key. A confirming message “ON
GPS? ” is shown and a confirmation of “YES” or “NO” is required.
To synchronize the A1 altimeter (barometric altimeter), press the
key (long press),
this takes you to the “MARK” page where the current GPS information is also shown. You
can then check if the GPS altitude is available and stable for at least one minute, then
press the
key (long press) to confirm; the display will then show “ALTIM SYNC”.
WARNING: if the recorder is activated is not possible to synchronize the barometric
altimeter.
If no GPS information is shown here, a GPS “FIX” has not been made as there may be no
or poor GPS reception.
The altimeters can be shown in metric (mt) or imperial (ft) units. To change the units of
display, go to (MAIN SETUP \ n. 28 V-AL). and change from “MT” to
“FT”.
3.3.2
ADDITIONAL ALTIMETERS
The additional altimeters A2, AG, A3, H1, H2 and HA can be shown
in any of the 5 customizable display fields on the Thermal Display
screen (highlighted here in red).
To show additional altimeter information in any of these
