DigiDesign Control 24, Руководство пользователя

Страница: 70 / 159

Control|24 Guide 60
Using Talkback
Whether using the internal or external micro-
phones, operation of the TALKBACK switch is
the same.
To use Talkback:
■
Press and hold the TALKBACK switch. This
switch does not latch and therefore Talkback is
only active for as long as you depress the switch.
The Talkback signal is sent to the AUX Out bus
to supply cue mix systems. Adjust the level us-
ing the TALKBACK knob.
The Talkback signal is also sent to the Slate out-
put on the rear or Control|24. The Slate output
can be sent to any recorder (ranging from a
Pro Tools input to a cassette deck) for a range of
purposes, including logging takes and the dicta-
tion or quick scratch recording of phrases or
ideas.
While Talkback is enabled, the Control Room
Main and Aux monitor signals are temporarily
attenuated—as if you pressed the DIM switch—
for as long as TALKBACK is held. The Talkback
mic signal, set by the Talkback level control, is
mixed with any signals routed to the AUX out-
puts.
Using Listenback
To enable the Listenback microphone:
1
Press the Utility switch.
2
Select “Monitor.”
3
Select “Talkback.”
4
If flashing, select “Listenback.” When the LED
is lights solid, Listenback is enabled.
5
Select “Exit” or press the Utility switch again
to return to normal operation.
When Listenback is enabled in conjunction
with talkback, the TALKBACK switch LED will
flash when engaged. When two-way communi-
cation is not enabled, the LED will light solid
whenever talkback is activated.
You can also engage Listenback independently
of Talkback by pressing LISTEN MIC TO MONI-
TOR. This method mutes the control room out-
puts entirely when activated. Pressing the
switch again toggles the Listenback microphone
off and returns the control room outputs to
their previous state.
Listenback Level
The external Listenback microphone level is
controlled by the LISTEN MIC LEVEL control in
the COMMUNICATIONS/ HEADPHONE sec-
tion. The LISTEN MIC TO MONITOR switch
routes the Listenback signal to the Control
Room Monitor section.