DigiDesign Control 24, Руководство пользователя

Страница: 117 / 159

Chapter 12: Mixing 107
Send Pan
In Flip mode, the channel encoders are used to
display and adjust pan position for stereo sends.
The channel encoder LED ring displays the rela-
tive position of the PAN control.
To toggle between left- and right-side pan controls
on a stereo send:
■
Press the flashing master PAN L<C>R switch
to toggle between left- and right-side pan con-
trols.
If the send is in multi-channel format, press the
REAR or F/R switches in the PANS section to ac-
cess the panning controls for panning between
a rear pair, or between front and rear, respec-
tively.
Repeatedly pressing each of these switches will
toggle between each side of any paired pan con-
trols and the divergence controls for that
switch’s pair.
The PAN L<C>R, REAR, and F/R switches each
have a second label below each primary func-
tion for the switch. These parameters are front
divergence (FRONT DIV), rear divergence (REAR
DIV), and front/rear divergence (F/R DIV), re-
spectively.
The switch LED will light solid when on the up-
per row and light flashing for the under row.
For stereo tracks, the PAGE switch is used to
navigate between left and right channels. The
default is LEFT, indicated when the PAGE switch
LED is lit solid.
Pressing PAGE will switch to right side panning,
that is indicated by the PAGE switch LED flash-
ing. Pressing PAGE again will toggle back to the
LEFT side.
Send Mute
In Send Flip mode, the channel MUTE switches
become SEND MUTE controls.
Pre/Post Toggling
In Send Flip mode, the PRE/POST switch LED
lights, to indicate that pre/post send switching
is available. The SWITCH ACTIVE switch LEDs
also light on any channels that have an active
send, to indicate that the associated encoder
switch has a function.
To toggle a send between pre- and post-fader:
■
In Send Flip mode, press the encoder switch
associated with any lit SWITCH ACTIVE LEDs to
toggle the send between pre-fader and post-
fader configuration.
The scribble strip will briefly show either “PRE”
or “POST” before reverting to its previous state.
To display pre- or post-fader status for a send:
■
Press the master PRE/POST switch. The chan-
nel’s scribble strip will display “Pre” or “Post” for
as long as the switch is pressed.
Only those channels with send destinations as-
signed will display this info. Other scribble
strips will remain blank.
The Pro Tools transport must be stopped be-
fore switching the pre/post state of a send.
In Send Flip mode, the encoder switch LED
will be lit to specify sends in a pre-fader con-
figuration.