Digga PD 30 HP-7, Руководство оператора

Страница: 21 / 44

21
1. Remove the shipping banding from around the attachment.
2.
ENSURE YOU HAVE READ THE SERIAL TAG ON THE DRIVE UNIT TO OBTAIN THE MAX FLOW AND PRESSURE RATINGS .
Ensure your machine flow and pressure settings are aligned with the requirements of the drive unit.
NEVER EXCEED THE MAX FLOW AND PRESSURE RATINGS AS WARRANTY WILL BE VOID.
3. Follow all standard safety practices and the instructions for installing an attachment as shown in your machine operator’s manual.
4. Lower the unit to the ground and remove any attachments from the front of the host machine.
5.
Attach the quick attach mounting frame or hitch to the host machine as per the manufacturers specifications. Ensure the locking
mechanisms on the machine are engaged & the attachment is secure.
6. Relieve any pressure from the auxiliary hydraulic system and after making sure there is no foreign matter on the hydraulic couplers,
connect the power and return couplers to the auxiliary hydraulic system of your machine. The list below shows the most common
places to “tap” into the hydraulic system on various types of machines.
• BACKHOES & EXCAVATORS - Auxiliary hydraulic outlets or bucket curl cylinder circuit.
• WHEEL LOADERS - Auxiliary hydraulic outlets or bucket tilt (dump) cylinder circuit.
7.
Route the hoses in such a fashion as to avoid pinching or chafing. Be sure the two hydraulic hoses are long enough to perform at
the full range of the auger drives operating motion. HIGH PRESSURE HOSES A & B - Route the hoses in such a fashion as to avoid
pinching or chafing.
8. The hydraulic block valve with pressure relief has 2 capped SAE 1 threaded fittings or code 62 flange ports onto the motor manifold
if no pressure relief is supplied. We recommend that high pressure hoses A & B should be custom made and fitted by a Qualified
Hose Assembler/Fitter. We also recommend the use of hoses rated to at least (350 Bar/5000 psi) working pressure. Hose size
is determined by Machine flow rate and should be calculated by the Qualified Hose Assembler/Fitter. Hoses A & B are normally
connected to the Auxiliary lines on the parent machine.
INSTALLING YOUR HIGH PERFORMANCE PLANETARY DRIVE
NOTE: IT IS IMPORTANT TO MAKE SURE THE LOCKING MECHANISM ON YOUR QUICK
ATTACH IS ENGAGED, THEREFORE LOCKING THE ATTACHMENT ONTO THE MACHINE.
8 COMMISIONING PROCEDURE