Dieci Apollo 25.6, Руководство по эксплуатации и обслуживанию

Страница: 62 / 235

B/41
When the weight to be handled is known, consult the load table (chapter “h“ vehicle technical sheets ) and identify the section
indicating the weight immediately above.
Example:
in the load table given as an example (fig.15/B), the weight of the load is 0.9 tons; go to the section with the 1.0 tons. (fig.15/B Pos.“A“).
The left-hand border (fig.15/B Pos.“B“) and the upper border (fig.15/B Pos.“C“) of this segment indicate the stability limits of the
vehicle relative to the considered load. Do not slant or extend the boom beyond the indicated limits. (fig.15/B Pos.“B-C“).
After insertion of forks from under the load and before lifting them, check indicator values of boom angle (fig.16/B Pos.“1“) and
extension (fig.17/B Pos.“1“).
As seen on the table, the lines start from the graduated scale for the angling and extension of the boom and cross the section
of the table. Check where the relevant lines for the parameters considered cross. If the cross point is within the maximum load
section or to the right (known load weight), the load is within the safety limits.
If the lines cross above or to the left of the section, do not make any attempt to lift the load. Retract the boom.
If, even with the boom completely retracted, the angular and extension values of the boom intersect outside of the maximum
load section, do not attempt to lift the load.
When the load is on the forks, retract the boom before lifting or lowering it. This will reduce the risk of the vehicle becoming unstable.
When the load is raised (for example, on a scaffolding) it should be let go (raise it) before retracting the boom completely.
Before depositing a load, check the load table to determine the maximum distance of the vehicle from the point of unloading.
It should be possible to deposit the load without intersecting the limits indicated to the left or above the maximum load section.
(fig.15/B)
(fig.16/B)
1
(fig.17/B)
1
Apollo
25.6
EN 1459
MAX 2,5 ton
-1
m
0
1
4
2
3
5
6
4 5 3 2 1 0
3,25
5,78
0°
10°
20°
30°
40°
50°
60°
66°
A
B
C
2,5
1,3
1,0
0,8
2,1
1,7
2,5
1,3
1,0
0,8
2,1
1,7
Cuchara con dientes
Cuchara mezcladora
Cuchara
Brazo en cuello
de cisne
Gancho
Cabrestante
Esta es solo una parte de los muchos equipos y herramientas disponibles para las máquinas Dieci. Para conocer la gama entera
de accesorios PÓNGASE EN CONTACTO CON NOSOTROS usando los datos indicados en el revés.
Equipos y herramientas específicos para cualquier exigencia
Cuchara para
materiales ligeros
Alargador de torre
Cesta portapersonas
de aluminio
Si
n
o
b
lig
a
ci
ó
n
d
e
n
eu
m
á
ti
co
s
m
a
ci
zo
s
o
p
ie
s
es
ta
b
ili
za
d
o
re
s
B
C
A