Dieci Apollo 25.6, Руководство по эксплуатации и обслуживанию

Страница: 110 / 235

C/37
- ATTENTION
:
- Read the SAFETY REGULATIONS (contained in this manual) carefully for the safety of all personnel and your vehicle.
(fig.67/C)
(fig.68/C)
(fig.69/C)
(fig.70/C)
1
STEErING SELECTOr
(fig.67/C Pos.”1”)
By moving the lever (fig.67/C Pos.”A”) 3 types of steering
are obtained:
1 - Normal steering - (fig.69/C)
This type of steering allows for frONT steering only.
To activate front steering, move lever “1” (fig.67/C) to po -
sition “ 2 ” (fig.67/C) shown on the functions sticker.
2 - beam steering - (fig.70/C)
This type of steering allows for maximum right steering
to the right and the left.
To activate beam steering, move lever “1” (fig.67/C) to
position “ 1 ” (fig.67/C) shown on the functions sticker.
3 - Crab steering - (fig.68/C)
This type of steering allows for crab steering, front and
rear parallel wheels (sideways movement of vehicle).
To activate cab steering, move lever “1” (fig.67/C) to po -
sition “ 3 ” (fig.67/C) shown on the functions sticker.
- attEntion -
Steering selection is done when the vehicle is stopped.
- attEntion :
For road travel it is mandatory to position the steering con-
trol lever in Position “1” (fig.67/C) blocked using the relevant
retainer (fig.67/C Pos.”C”); (4 wheel steering mode).
-
attEntion
:
Before selecting a new steering type, align the wheels as
explained in the procedure below. Wheel alignment must
also be performed with the vehicle at a standstill.
Alignment (standard)
1. Position selector “A” (fig.67/C) on the position marked
with “1” (fig.67/C) on the functions sticker.
2. Turn the steering wheel, until the rear wheels have been
completely straightened.
3. Position selector “A” (fig.67/C) on the position marked
with “2” (fig.67/C) on the functions sticker.
4. Turn the steering wheel, until the front wheels have been
completely straightened.
5. At this point, the front and rear wheels are aligned and
the desired steering type can be selected.
- attEntion :
Periodically it is advisable to align the wheels (8-10 hours)
depending on the continued use of the vehicle.