Dickey-John Flex4, Руководство оператора

Страница: 31 / 152

OPERATOR’S MANUAL
NOTE: Interchange the Spread Width
Bar window with the Channel
(Rate) window by pressing the
screen and swiping to desired
location.
Control channel windows display target application rates (APR) when the
vehicle is stationary and the actual application rate when spreading material
for granular and liquid materials.
– Application of granular material (pounds/kilogram) per mile (km) or
area based (pounds per square foot or grams per square meter)
(lbs/acre)
– Application of liquid material gallons (liters) per ton based on the
granular applications rate or gallons (liters) per mile (km) and
gallons (liters) per square yard (meter) (gal/acre)
An auxiliary channel window allows selection of another granular or liquid
channel with the same units available as channel one and two.
Target rates of product control channels can be changed by pressing the
respective
Rate Increase/Decrease button on the switch module. An
audible beep indicates a rate adjustment change.
Channels are turned on and off by pressing the respective CH ON or CH
OFF function buttons. The channel window reads “OFF” when the channel
is selected to be off and returns to the rate when turned on again. Channel
must be selected using spread width knob.
(2) DISPLAY FUNCTION BUTTONS
Twelve buttons are located on the left and right side of the tablet user
interface screen providing screen navigation and quick adjustment to
system settings.
(3) SPREAD WIDTH BAR
Spread width bar indicates spinner operation and spread width in percent.
Value is adjusted using the spread width knob on the switch module.
Rotating the spread width knob on the switch module changes the rotational
speed of the spinner and indicates the percentage on the spread width bar
display. The bar is at the 100% position when the knob is clockwise
corresponding to maximum spinner speed. Pressing the spinner left and
right arrows positioned on the sides of the spread width bar indicates the
selected spinner to be changed. Both can be adjusted simultaneously.
(3) ROAD/AIR TEMPERATURE SENSORS
When enabled, the current road/air temperature displays on the Operate
screen with current readings and triggers an audible alarm when outside of
defined parameters.
(3) BOOM SECTIONS
Boom nozzle graphics appear on screen, when enabled, to indicate boom
section on/off status.
(3) CONVEYOR
When enabled, a left/right conveyor symbol and a front/rear conveyor
symbol provides current position and can be changed by pressing the
respective buttons.
28 / OPERATE SCREEN OVERVIEW
Flex4 Pro
TM
Control System
6010541 Rev A