Dickey-John Flex4, Руководство оператора

Страница: 18 / 152

OPERATOR’S MANUAL
1. The PCECU module is mounted in the cab and should be placed near
the Accessory Plate that contains the USB hub, PCAN adapter, and
DC-DC converter. Mounting location can be on the floor, cab back, or
center console.
– Verify that the cab harness reaches between the PCECU and the
Accessory Plate.
2. Use the enclosure as a template to mark the location of the mounting
holes.
3. Drill four 9/32 inch diameter holes where marked. (Do we provide the
hardware to mount)
4. Mount with the label side of module facing out. Do not mount with the
connector facing up (see Caution).
5. Connect the PCECU to the designated location on the cab harness.
Do not install the module in any orientation other than shown in
(Figure 7). The connection wires must not be mounted upward as
moisture can collect inside the unit and damage the circuits.
MISCELLANEOUS COMPONENTS
RAM TOUGH HUB
USB distribution point for the system. Provides connections to the
USB-CAN adapter, camera adapter, and the USB data port below the
Operator Switch Module.
USB CAN ADAPTER
Provides a communication bridge between the tablet and the CAN bus.
DC-DC CONVERTER
Provides regulated 5V power to the tablet.
KEYBOARD
A keyboard is required to program and calibrate the system. The keyboard
has been environmentally hardened for use in the ice control field. After
programming and calibration, the keyboard is disconnected and stored.
GROUND SPEED SENSOR
The ground speed sensor generates vehicle speed information for the
console. Sensor electrical pulses proportional to the vehicle ground speed
are vital to system operation because true vehicle ground speed is
necessary for accurate product application. The system can function with a
variety of electronic and mechanical speedometer sensors, such as hall
effect and reluctance sensors.
Flex4 Pro
TM
Control System
6010541 Rev A
COMPONENT OVERVIEW / 15