70
Chapter 6 Command Definitions
6.6.5
C7RTI – CCS SS7 Route Initiate
Synopsis
This command is used to initiate an SS7 Route (
C7RT
) to a Destination Point Code (
DPC
) within a Network
Context (
NC
). An SS7 Route utilizes one (
LS1
) or two (
LS2
) link sets which route via adjacent point codes to
reach the eventual destination (
DPC
).
On a per network context basis, a default MTP route may be specified. On a per network context basis, traffic
for all point codes not known to the Signalling Gateway are routed to the default route. A default route can
be specified by setting the DPC value on the route to DFLT.
See
Section 7.2, “Signaling Configuration” on page 136
for a more detailed description of the SS7 signaling
configuration.
Syntax
C7RTI:
C7RT
=,
DPC
=,
LS1
=,
NC
=,[
LS2
=,][
LSH
=,][
LABEL
=,];
Prerequisites
•
The
NC
must be the same as the NC of the underlying link sets.
•
The
DPC
/
NC
combination must be unique.
•
The link set specified has already been initiated.
•
If the route is to an adjacent point code, then all links in the linkset to that point code must be either
inhibited or blocked.
•
Only one default Route can be configured per Network Context.
•
If a default route is specified, a network context cannot be configured with a
DPC
of 0.
Attributes
CONFIG
Examples
C7RTI:
C7RT
=1,
LS1
=1,
DPC
=130,
LABEL
=ROUTE130;
