41
INVERTER BOX INTERNAL TEMPERATURE
Displays the box internal Temperature.
Ti 30
°C
CAPACITOR TEMPERATURE
Displays the power capacitors temperature
Tc 40
°C
INPUT ACTIVATION STATUS
Displays the input signal activation Status
1= enabled input 0= input not enabled
In 0
OUTPUT ACTIVATION STATUS
Displays the output relay activation Status
1= enabled input 0= input not enabled
Ou 0
STATUS RS 485 (SLAVE connection)
Displays the status of the inverter SLAVE connected to the
inverter MASTER.
XX-XX = no SLAVE inverter connected
S1-XX = inverter SLAVE1 connected
XX-S2 = inverter SLAVE2 connected
S1-S2 = inverter SLAVE1 e SLAVE2 connected
S1-S2
Back to the parameter
SYSTEM PRESSURE
P 3.5
bar
Set pressure quick adjustment
tasto
istruzione
display
ENTER
+
To increase the SET PRESSURE by 0,1 bar
P 3.5
P 3.6
ENTER
+
To decrease the SET PRESSURE by 0,1 bar
P 3.5
P 3.4
Display the serial number and the firmware version
tasto
istruzione
display
START / STOP
DGFIT out of service
OFF
+
Display the SERIAL NUMBER and the
FIRMARE version
SN – DGF 1501 …
PRIMING AND STARTING UP
-
Do not run pumps dry
- Before starting the pump, make the
filling of all pumps
-
In the pressure units
, the filling is for single pump by turning off all other pumps
- When the pump is completely filled with water, bring in TEST mode (manual operation) and
prime
the pump
by opening the discharge valve gradually
- When the pump is primed, stop the manual mode by pressing STOP and
switch to automatic
mode
by pressing START.
