Detroit Radiant Products DST-60N, Руководство по установке, Страница: 39 / 52

39
DST Series
4.0 Operation • Operating Instructions
Operating Instructions
BEFORE OPERATING
, smell all around the appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle to the floor. Refer to page 1 “If you
smell gas” and on safety label affixed to the heater.
DO NOT use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas
control which has been under water.
Lighting Procedures
:
1
STOP! Read the safety information in the manual prior to proceeding.
2
Set the thermostat to the lowest setting.
3
Turn OFF all electrical power to the appliance.
4
Turn manual shutoff clockwise to “OFF”. See Figure 3.19.
5
Wait five (5) minutes to clear out any gas. If you smell gas STOP! Follow the safety information
found on page 1 “If you smell gas” and on safety label affixed to the heater. If you do not smell gas,
proceed to step 6.
6
Turn manual shutoff knob counterclockwise to “ON”.
7
Turn “ON” all electrical power to the appliance.
8
Set thermostat to desired setting.
9
If the appliance will not operate, follow instructions below to turn “OFF” gas to the appliance and call
your service technician or gas supplier.
Shutdown Procedures
:
1
Set the thermostat to the lowest setting.
2
Turn OFF all electrical power to the appliance if service is to be performed.
3
Turn manual shutoff knob clockwise to “OFF”. See Figure 3.19.
Do not
force.
If the heater’s internal diagnostic LED displays any of the signals listed in Charts 4.1-4.2, address the
indicated problem as outlined.
4.0 Operation
WARNING
!
This appliance does not have a pilot ignition. It is equipped with an ignition device which
automatically lights the burner. Do not attempt to light the system by hand.
WARNING
!
Use only your hand to turn the manual shut off. Never use tools. If the
knob will not turn by hand, don’t try to repair it; call a qualified technician.
Force or attempted repair may result in a fire or explosion.