Detection Systems
Abacus User Guide
Chapter 4.30
1502 081010
Part - Set
1502 081010 BAD
Kitchen PIR
03 Nite
1502 081010 TRBL
Kitchen PIR
03 Nite
1502 081010 TRBL
Power
1502 081010
Reset Power
1502 081010 TRBL
Supply
1502 081010
Mains ok
1502 081010 TRBL
Phone
1502 081010 TRBL
Comms
System was unset by
a keyswitch fitted to
the system (your
system would
require a keyswitch
to be fitted).
Displays Master for
all area or the
appropriate Area
operated.
Area 1 was set using
the keyswitch fitted
to the system.
Either Area 2 was
omitted, when the
system was set, by a
main or master code
or was unset by that
code. Area 2 was
unprotected.
(Printout/Display
will give a similar
indication for Area 1
or Area 3, Area
word may be
reprogrammed for location name).
When the panel was set, zone 3A, the lounge detector was omitted or on
test.
When the panel was set, all zones programmed as part were omitted (i.e.
all of the bedrooms).
On attempting to set the panel, zone 3, the kitchen PIR was in an alarm
condition and caused the system to fail to set. The installation was not
protected.
The kitchen detector as signalled a trouble state (see detector specification
for reason) for panels with this facility see Chapter 1 System Features,
The panel has detected that the battery back up power supply is low or
disconnected (i.e. battery requires replacement or if after a mains failure
recharging).
The battery has now recharged to a level to be able to start supporting the
system again, or been replaced.
The mains supply to the panel has been interrupted or disconnected.
The mains supply has been restored to t he panel.
A non-plug on DS communicator or Red care communicator as detected a
line fault.
A plug on DS communicator has stopped communicating with the Abacus
panel.
