Detection Systems
Abacus User Guide
Chapter 4.27
At this display press
0/ESC
key
and then the
4
key to return to the Day mode, or carry out further tests
as follows.
Bell Test and Sounder Tests
At this display, press the
2
key for bell/sounder test.
At this display, press the
1
key to test the Bell (Siren) and Strobe.
At this display, the Bell (Siren) will sound and the Strobe will flash. Press
the
0/ESC
key the bell (Siren) will stop but the strobe will continue to flash
until the panel is returned to the day mode.
At this display, press the
2, 3, or 4
key as required for the area sounder to
be tested.
(Area sounders A2 and A3 are only available on the Abacus
8/80, 15R and 72 panels).
At this display, press the
1, 2, 3
and
4
key in turn to check different sounder
tones are working correctly at all sounders. When completed, press the
0/ESC
key three times, followed by the
4
key, to return to the day mode.
Alarm Fault Display
Date
Time
Zone state or condition
If
the
descriptor message has been programmed, when reading the log press the
1 key for the additional information to be displayed for 2 second.
Zone No.
Zone type or
descriptor
See log information explained on next page.
Reading the Log
From the day mode, enter the Main or Master code.
(
Version 5000 or later software, fast entry to log is available, if in day mode,
display reads Alarm, by pressing the
YES/PART
k ey twice).
At this display, press the
NO
key. (XXXXXX = Code holders name if
programmed).
On Version 7000 software, this display appears to allow you to return to the
day mode if you have made a mistake, press
YES/PART
key to continue
.
At this display, press the
NO
key.
(If panel is in an alarm condition, this menu is not displayed).
1=Zone 2=Bell
4=Active
1=Bell 2=A1 LS
3=A2 LS4=A3
LS
Test
1=Bell 2=A1 LS
3=A2 LS4=A3
LS
1=Part
2=Exit
3=Entry 4=Alarm
0712 03:46P
System Off
Hello XXXXXX
Set System?
Omit Zones ?
YES: to Continue
No: to Quit
0712 03:46P TRBL
04 Nite
