Detcon SmartWireless CXT, Руководство по установке и инструкции оператора

Страница: 37 / 55

Se nti nel C X T
Sentinel CXT Instruction Manual Rev. 1.7 Page 31 of 49

M odbus ™ interface.
Upon entering this menu, the SmartWireless® CXT controller will automatically initiate a function test that
displays every pixel LCD display. The controller then performs a function test of the LED drivers by
activating all four LEDꞌs. After the LED test, the controller initiates a test for the external reset switch
which lets the user know when the reset switch is pressed.
The user will be prompted:
1. To "press (swipe) enter key (marker) to continue" which will initiate the relay driver test and the
controller will then reset all the relays and turn on the alarm 1 relay.
2. To "press (swipe) any key (marker)" which will turn on the alarm 2 relay.
3. To "press any key" and the alarm 3 relay will be turned on.
4. To "press any key" and the fault relay will be turned on.
5. To "press any key" and all the relays will be reset.
6. Connect COMM1 (master) to COMM2 (slave) for a Modbus
™
loop back test at different baud
rates and “press any key” to continue or swipe any marker to stop the test.
N O T E
When performing the Modbus
™
loop back test, the loop back cable should be installed
between the C O M M 1 (Master) port and the C O M M 2 (Slave) port. Disconnect all other
external Modbus
™
interfaces from the loop and bypass any installed modules.
5.4.7 T i m e a nd D a te
1. Upon entering this menu, the LCD will display:
T IM EA N D D A T E:
##:##:## | ##:##:##
|
[T IM E] [D A T E]
2. Verify that [T IM E] is selected and swipe the magnet over the ENTER marker to enter the SET
TIME menu.
3. Swipe the magnet over the markers of the up or down arrows to move the arrow prompt "
→
"to the
desired field.
4. A swipe over the ENTER marker will select the field indicated by the arrow prompt "
→
" and the
value can be changed by swiping over the markers of the up or down arrows.
5. Another swipe over the ENTER marker will save the selected value.
6. Once the desired values have been set, move the arrow prompt to "Update Time" and swipe the
ENTER marker to update the time with the changes entered.
7. Swipe the magnet over the marker of the down arrow and verify [D A T E] is selected.