16
MFT4X8 man
16
MFT4X8 man
ENGLISH
ENGLISH
ASSEMBLY
ASSEMBLY
STEP 9
STEP 9
WIRING THE TRAILER
NOTE:
Only a qualified technician should perform the electrical service that may be needed to
enable your particular make/model vehicle to power the Trailer’s 12 volt DC lighting system. This is
beyond the scope of this manual.
�ig.8-1
WHITE GROUND WIRE
BROWN
BROWN
BROWN
BROWN
BROWN
BROWN
YELLOW
YELLOW
YELLOW
LEFT TAIL LIGHT (30L)
RIGHT TAIL LIGHT (30R)
GREEN
GREEN
GREEN
WIRE HARNESS
CONNECTOR PLUG
LEAVE EXCESS WIRE HERE
LEAVE EXCESS WIRE HERE
WIRE LEAD
FROM
SIDE RUNNING LIGHT
(38)
WIRE LEAD
FROM
SIDE RUNNING LIGHT
(38)
1.
Have a qualified service technician install a 4-wire, 12 VDC connector in the trunk area of your
vehicle.
2. Locate the vehicle’s connector plug near the Trailer’s Coupler (2) and lay out the Trailer’s wiring
harness wires.
NOTE:
fig.8-1 and 8-2 show the trailer right side up. Keep in mind, the trailer is actually upside
down at this point to make wiring installation easier, so the left and right sides appear reversed.
