DAEnetIP3
User Manual
-
43
-
Figure 39.
Two DAEnetIP3 controllers connected via UTP cable
Table 9.
Example 1 settings
DAEnetIP3 [1] (inputs)
Network Settings
Eth IP address = 192.168.0.100
Eth Mask = 255.255.255.0
Eth GW = 192.168.0.101
Remote Server IP:Port = 192.168.0.101:1005
Working mode = Ethernet 10/100 Mbit
Analog Input 1 (Port C
– Pin 1)
Refresh=1, LT=100,HT=150,LH=10,HH=10, Mode = Low,
PortA Pin = Pin 1, Remote = true
Digital Input 1 (Port B
– Pin 1)
Mode = Set output during rising slope, PortA Pin = Pin 2,
Remote = true
DAEnetIP3 [2] (outputs)
Network Settings
Eth IP address = 192.168.0.100
Eth Mask = 255.255.255.0
Eth GW = 192.168.0.101
Local Port Range = 1005:1009
Digital Output 1 (Port A - Pin 1)
Mode = On/Off setting and remote
Digital Output 2 (Port A - Pin 2)
Mode = On/Off setting and remote
10.4.2.
Example 2: Two DAEnetIP3 controllers connected
via WLAN
This example (figure 40) is extension of the previous one. It demonstrates how
two DAEnetIP3 controllers can be connected to each other but this time over WLAN.
It is used Wi-Fi router. Again one analog and one digital inputs of one DAEnetIP3
controller control two digital outputs of another DAEnetIP3 controller. It used the Wi-
Fi interface, so the Wi-Fi network settings must be set properly.