DAEnetIP3
User Manual
-
19
-
7. Digital outputs port (Port A)
DAEnetIP3 has 16 bit digital output port with 10 kOhm pull-down resistors to
GND.
7.1.
Port A web page
Figure 12.
Port A web page
– 16 digital outputs
7.2.
Setting the digital outputs
The 16 bit digital outputs port can be set in two ways. It is possible to set single
output line in low/high level or set the whole port. In some modes the user can not set
the outputs manually, because they are set by time events, input signals or another
DAEnetIP3 controller. Via web browser, it is possible to be set only at once all of
them.
7.3.
Reading the digital outputs state (status)
It is possible to read digital output states anytime. User can read single line or the
whole port (all the 16 output lines).
7.4.
PortA initial state
Bellow are given the initial states of PortA depending on the selected mode:
On/Off setting - last state before power off
On/Off setting and digital input - according to the input
On/Off setting and analog input - according to the input
